https://dataanalyzers.com/That we’ve made on the pad and it leads to contact number one. we’re just gonna go ahead and keep on moving with the others to establish other connections Houston Data Recovery that’s two that’s three so that’s it i think we’re all set the only thing. i forgot to do is to add power and ground to our device okay let’s check this thing for shorts now shorts good so here. https://dataanalyzers.com/We have our control panel we need to assign our signals to the pins. that we have to do the assignment you look at the schematic and you look at the corresponding Houston Data Recovery number on the needle. that you’ve attached to that specific signal and uh in the software section you just need to kind of navigate and label. https://dataanalyzers.com/Where each pin goes so now we’re going to set it up to read into a dump file um and we’re just gonna go with default optimal settings to read it. reading at five megabytes per second so two hours later we should have an extraction finally. it’s done we can add that information to the transformation graph let’s have a look at our content page designer. https://dataanalyzers.com/Now i did mention that it looks fairly clean in the beginning now. how do i determine that if we look at the end here we can see that the Data Recovery information in these vertical lines the consistency i should say the consistency of these vertical lines is fairly solid. https://dataanalyzers.com/We don’t have any random dots here all that much. if we go into let’s say zoom we see these dots every now and then but that’s not a lot ecc should be able to take care of that so let’s go ahead and try to find ecc automatically so , the ecc is found automatically we have ranges for at the end for service area going ahead hit execution and it’s off to the races so one thing that is worth mentioning based.